Bg H5000 Pilot Controller Manuale Utente Scaricare il pdf (Pagina 1)

5 V Analog input / 0V to +5V (Con A) 5 V Analog input / 0V to +5V (Con B)

Color Description Channel Color Description Channel

1 - Screen - 1 - Screen -

2 -- -2 -- -

3 Black 0 Volts - 3 Black 0 Volts -

4 Red 5V Supply - 4 Red 5V Supply -

5 SD Signal 0V to +5V Analog 1 5 SD Signal 0V to +5V Analog 4

6 SD Signal 0V to +5V Analog 2 6 SD Signal 0V to +5V Analog 5

7 SD Signal 0V to +5V Analog 3 7 SD Signal 0V to +5V Analog 6

8 -- -8 -- -

SD = Sensor depensdent

0 Volt to 5 Volt sensors can be wired into either Terminal A or Terminal B. If you plug

a 0 - 5 Volt analog input into Terminal 1 then the analog channels will be 1, 2 & 3, if

connected to Terminal 2 then they will be channels 4, 5 & 6.

Masthead unit Paddlewheel sensor

Color Description Color Description

1 - Screen 1 - Screen

2 Orange 12V Supply 2 --

3 Black 0 Volts 3 Black 0 Volts

4 --4 Red 5V Supply

5 Blue Wind angle Phase 5 --

6 Green Wind angle Phase 6 --

7 Red Wind angle Phase 7 --

8 Violet Wind speed 8 Green Speed

Paddlewheel & Sea temp

Color Description

1 - Screen

2 --

3 Black 0 Volts

4 Red & White 5V Supply

5 Yellow Sea Temperature

6 --

7 --

8 Green Speed

www.bandg.com

*988-10709-001*

ENGLISH

Analog Module

Install Guide

Paddle & Sea temp connector

10 K ohm resistor required

between terminal 3 & 5

12345678

1 2

Install Guide 1
12345678 2

Sommario

Pagina 1 - Install Guide

5 V Analog input / 0V to +5V (Con A) 5 V Analog input / 0V to +5V (Con B)Color Description Channel Color Description Channel1 - Screen - 1 - Screen -2

Pagina 2 - 12345678

Installation1: Find a suitable location for the module.Mount the module vertically. Ensure that there is at least 100 mm clearance between the connect